Hardware & buying
One small board gives Handsy a way to see and use your iPhone. Start with the supported board below, then choose the connection that fits your phone.
This page is the board you buy and flash yourself. A plug-and-play Handsy device is separate, not for sale, and has no final price: join the Handsy device waitlist. Stores by region, with no prices listed, are on where to buy a XIAO ESP32S3.
The board
Section titled “The board”Use the Seeed Studio XIAO ESP32S3, standard version, with 8 MB flash and 8 MB PSRAM. This is the board supported by the website’s browser installer.
Amazon · boardSeeed Studio XIAO ESP32S3 Look for the standard 8 MB flash / 8 MB PSRAM version.
Before ordering, check the full model name. The Sense, Plus, ESP32-C3, and other ESP32 variants are not supported by this installer. Choose the standard XIAO ESP32S3 for this guide.
Attach the antenna
Section titled “Attach the antenna”Connect the included Wi-Fi/Bluetooth antenna to the board’s antenna socket before pairing. Without it, Bluetooth may not connect, or may work only with the board right beside your phone. See the antenna installation guide for the connector location.
Connect it to your iPhone
Section titled “Connect it to your iPhone”| Your phone | What to prepare |
|---|---|
| USB-C iPhone | A short USB-C to USB-C data cable between the phone and board. |
| Lightning iPhone | A Lightning to USB 3 Camera Adapter with a charger in its Lightning port, and a USB data connection to the board. See Lightning iPhone. |
Handsy supports iPhone XS or newer, with iOS 18 or later. A USB-C iPhone powers the board; with a Lightning adapter, the charger does. Keep cellular data available for your AI service while the phone uses the board’s Wi-Fi for Screen Mirroring.
Check that your cable supports data transfer, not just charging, and keep it short (about 30 cm / 1 ft). You also use it to install the firmware from your computer. The USB-C cable link is for USB-C phones; Lightning phones need the adapter connection above.
If the iPhone shows no pointer or keyboard from the board, or the browser installer cannot see the board, try a different known-good data cable first.
Before the first run
Section titled “Before the first run”You will also need a computer with Chrome or Edge to install the board firmware once. With the app, the task then runs with your iPhone and the board. With the CLI, your computer stays nearby and runs the agent over Bluetooth; the CLI needs board firmware v0.2.2 (TestFlight channel). You can start with a free AI service available in the app. If you choose your own service, have its endpoint and API key ready for setup.
When the hardware arrives, follow Using the app. The installation video and phone walkthrough are embedded there, alongside each step.
Amazon links & supporting Handsy
Section titled “Amazon links & supporting Handsy”These are the same Amazon purchase links used on the Handsy homepage. Buying through them can support the project.
* Affiliate link. As an Amazon Associate I earn from qualifying purchases.
