On your phone

Start with the app.

Installing the board firmware needs Chrome or Edge on a computer, once. Everything else happens on your iPhone.

Handsy AI works with an iPhone. The board itself is set up from a computer, in Chrome or Edge.

A one-time setup

Give your board
a pair of hands.

Install the firmware right here in your browser.
Then plug the board into your iPhone.
Your computer's job is done.

Connect a XIAO ESP32S3 to your computerA USB data cable connects a laptop to the USB-C port on the small XIAO ESP32S3 board.XIAOESP32S3BOOTYour computerXIAO ESP32S3

Board firmware

XIAO ESP32S3

Checking latest release

Getting things ready.

Looking for the latest firmware for your board.

Checking firmware…

Chrome or Edge on a computer · USB data cable

Not using a XIAO ESP32S3?

Other ESP32-S3 boards usually work too.

Needs
  • Native USB (USB-C straight to the chip)
  • 8 MB flash or more
  • 8 MB PSRAM or more
Won’t work
  • ESP32-C3, C6, S2 or the original ESP32
  • Boards with a CH340 / CP2102 USB-serial chip

Your AI can help, too.

Then, over to your iPhone

Unplug. Plug in. Open Handsy AI.

The app will walk you through connecting the board and getting started.

Scan with your iPhone

Watch it once

Connect, pick the board, wait half a minute.

Common questions

Not answered here? Contact support

The installer runs on esptool-js ↗

My board doesn't show up.

Use a USB cable that carries data, not a charging-only cable. Connect directly to the computer and close any apps using the board.

Still missing? Hold BOOT while plugging in the board, then release it and try connecting again.

It says “Failed to connect with the device”.

A board running Handsy firmware may not offer a serial port the installer can use. Unplug it, hold BOOT while plugging it back in, release, then click Connect board and pick the new port.

Step-by-step fix ↗
Which board should I use?

This installer is for the Seeed Studio XIAO ESP32S3, the standard version with 8 MB flash and 8 MB PSRAM. Other ESP32-S3 boards with native USB, at least 8 MB flash and 8 MB PSRAM should work but aren't tested. Other chips, such as the ESP32-C3, aren't supported.

See the board ↗
Can I do this on my iPhone?

Use Chrome or Edge on a computer for this installation. Once it's finished, the board works with your iPhone. You won't need the computer to run Handsy.

What happens to the firmware already on my board?

Installation replaces the board's current firmware. Back up anything you need before installing. It doesn't change anything on your computer or iPhone.